Getting started using Makefiles
This guide assumes that your chai3d installation is located in your home folder (e.g. ~/chai3d)
Prerequisites
- On Linux, make sure that the following development libraries are installed on your system:
- GLUT
- libusb-1.0
- libasound2
- On Mac OS X, make sure that XCode and the XCode Command Line Tools are installed.
Installation
- (optional) On Linux, install the drivers and device management permissions for the following hardware:
- Force Dimension (see
~/chai3d/external/DHD/doc/linux/readme.txt) - Leap Motion (see
~/chai3d/extras/tdLeap/doc/linux/readme.txt) - Sixense (see
~/chai3d/external/sixense/doc/linux/readme.txt) - 3DSystems (see
~/chai3d/extras/hdPhantom/doc/linux/readme.txt)
Compilation
- open a terminal
- cd to
~/chai3d - run
make - (alternative) to build with debug information, run:
make CFG=debug
Trying the examples
- from the terminal:
- cd to
~/chai3d/bin - run examples (e.g.
./01-mydevice) - from the file manager:
- navigate to
~/chai3d/bin - double-click on example executable (e.g.
01-mydevice)
Reading the documentation
- check out the documentation page

